A/T Housing Bearing Installation
Special Tools Required
Driver attachment, 78 x 90 mm ( 07GAD-SD40101)
Handle driver ( 07749-0010000)
Driver attachment, 42 x 47 mm ( 07746-0010300)
Snap ring pliers ( 07LGC-0010100)
| 1. | Install the bearings in the direction shown.
|
| 2. | Expand each snap ring with the snap ring pliers, and install the mainshaft bearing (A) and countershaft bearing (B) part-way into the housing.
 AB07LGC-0010100 |
| 3. | Release the pliers, then push the bearing down into the housing until the snap ring snaps in place around it.
|
| 4. | Expand the snap ring of the idler gear shaft (A) with the snap ring pliers, and install the bearing part-way into the housing.
 A07LGC-0010100 |
| 5. | Release the pliers, then push the bearing down into the housing until the snap ring snaps in place around it.
|
| 6. | After installing the bearings verify that the snap rings (A) are seated in the bearing and housing grooves, and that the ring end gaps (B) are correct.
 B: 0-7 mm (0-0.28 in.)A |
| 7. | Install the idler shaft.
|
