Honda Accord ESM 2003 · Service Manual Service Manual 2003

Fuel Line/Quick-Connect Fittings Installation (4D)

Fuel Line/Quick-Connect Fittings Installation

1.Check the contact area (A) of the line (B) for dirt or damage, and clean it if necessary.

S5A1A00A20326428001KCAD01AB

2.Insert a new retainer (A) into the connector (B) if the retainer is damaged, or after
  • replacing the fuel rail.
  • replacing the fuel feed line.
  • replacing the fuel pump.
  • replacing the fuel filter.
  • replacing the fuel gauge sending unit
  • removing the retainer from the line.

S5A1A00A20326428001KCAD02BA

3.Before connecting a new fuel tube/quick-connect fitting assembly (A), remove the old retainer from the mating line.

SDA3AE4A20326428001KCAD01AA

SEA3EK0A20326428001KCAD01A*: The illustration shows except ECONO model.

SEA3EK0A20326428001KCAD02A*: The illustration shows except ECONO model.

4.Align the quick-connect fittings with the line (A), and align the retainer (B) locking pawls with the connector (C) grooves. Then press the quick-connect fittings onto the line until both retainer pawls lock with a clicking sound.

NOTE: If it is hard to connect, put a small amount of new engine oil on the line end.

Connection with new retainer:

S5A1A00A20326428001KCAD05CBA

Reconnection to existing retainer:

S5A1A00A20326428001KCAD06CBA

5.Make sure the connection is secure and that the pawls are firmly locked into place; check visually and by pulling the connector.

S5A1A00A20326428001KCAD07

6.Reconnect the negative cable to the battery, and turn the ignition switch ON (II). The fuel pump will run for about 2 seconds, and fuel pressure will rise. Repeat two or three times, and check that there is no leakage in the fuel supply system.