Intermediate Shaft Reassembly (4D)

Intermediate Shaft Reassembly

Exploded View

INTERMEDIATE SHAFT RINGFLANGE BOLT
10 x 1.25 mm
39 N·m
(4.0 kgf·m, 29 lbf·ft)EXTERNAL SNAP RINGPack the interior of the outer seal.INTERMEDIATE SHAFTBEARING SUPPORT RINGINTERNAL SNAP RINGBEARING SUPPORTDOWEL BOLTS
10 x 1.25 mm
39 N·m
(4.0 kgf·m, 29 lbf·ft)OUTER SEAL
Replace.SET RING
Replace.INTERMEDIATE
SHAFT BEARING
Replace.

Special Tools Required
Driver ( 07749-0010000)

Attachment, 52 x 55 mm ( 07746-0010400)

Attachment, 35 mm I.D. ( 07746-0030400)

Oil seal driver ( 07GAD-PH70201)

NOTE: Refer to the Exploded View as needed during this procedure.

1.	Clean the disassembled parts with solvent, and dry them with compressed air. Do not wash the rubber parts with solvent.

2.	Press the intermediate shaft bearing (A) into the bearing support (B) using the special tools and a press. PRESS07746-001040007749-0010000AB

3.	Install, then seat the internal snap ring in the groove of the bearing support.

4.	Press the intermediate shaft (A) into the shaft bearing (B) using the special tool and a press. 07746-0030400BAPRESS

5.	Install, then seat the external snap ring (A) in the groove of the intermediate shaft (B). AB

6.	Install the outer seal (A) into the bearing support (B) using the special tool and a press. PRESS07GAD-PH70201ABPack the interior of the outer seal.

7.	Install the set ring.