Rear Door Weatherstrip Replacement (4D)

Rear Door Weatherstrip Replacement

NOTE:

• Take care not to scratch the door.
  
• Use a clip remover to remove the clips.
  

1.	At the center pillar, remove the door stop mounting bolt (A). Fastener LocationsA: Bolt, 1B: Screw, 2C: Clip, 30A 8 x 1.25 mm 29 N·m (3.0 kgf·m, 22 lbf·ft)CCCFFrom outside:DDDDEECD: Clip, 4BBE

2.	Remove the screws (B) securing the rear of the door weatherstrip (C).

3.	Detach the clip (C, D), then remove the door weatherstrip (E).

4.	Install the weatherstrip in the reverse order of removal, and note these items: Replace any damaged clips. Make sure the weatherstrip is installed in the holder (F) securely. Apply liquid thread lock to the door stop mounting bolt before installation. Check for water leaks.