Subframe Replacement (4D)
Subframe Replacement
Front Subframe Torque
After removing the subframe mounting bolts, be sure to replace them with new ones.
FRONT SUSPENSIONSUBFRAME
Bottom view:ForwardLOWER INSULATORFRONT SUSPENSIONFRAME FRONT
BRACKETSPECIAL BOLT
14 x 1.5 mm
103 N·m (10.5 kgf·m,
76 lbf·ft)
Replace.12 x 1.25 mm
54 N·m
(5.5 kgf·m, 40 lbf·ft)8 x 1.25 mm
22 N·m
(2.2 kgf·m, 16 lbf·ft)FRONT SUSPENSION
SUBFRAME REAR BRACKETFRONT SUSPENSION
SUBFRAME FRONT DAMPERFRONT SUSPENSION
SUBFRAME REAR DAMPERSPECIAL BOLT
14 x 1.5 mm
103 N·m (10.5 kgf·m, 76 lbf·ft)
Replace.12 x 1.25 mm
93 N·m
(9.5 kgf·m, 69 lbf·ft)To body.Bottom view:ForwardLOWER INSULATOR10 x 1.25 mm
59 N·m
(6.0 kgf·m, 43 lbf·ft)STEERING GEARBOX
STIFFENER10 x 1.25 mm
22 N·m
(2.2 kgf·m, 16 lbf·ft)FRONT SUSPENSION
SUBFRAME MIDDLE
MOUTING RUBBER10 x 1.25 mm
49 N·m
(5.0 kgf·m, 36 lbf·ft)12 x 1.25 mm
44 N·m
(4.5 kgf·m, 33 lbf·ft)FRONT SUSPENSION
SUBFRAMETo body.To body.To body.To body.
Front Subframe Alignment
NOTE:
- Before removing the subframe, make the appropriate lines where the subframe that line up with the edge of the rear bracket for reinstallation.
- When installing, align both installation reference holes in the subframe with both reference holes in the body using a screwdriver or tapered punch as a guide.
- After mounting the subframe and brackets loosely, align the reference marks with the edge of the rear brackets then tighten each bolts.
Reference holes alignment:SUBFRAMEREFERENCE HOLE(Body side)INSTALLATION
REFERENCE HOLE
(Subframe side)SCREWDRIVER or
TAPERED PUNCHINSTALLATION
REFERENCE HOLESFRONT SUSPENSION
SUBFRAME MIDDLE
MOUNTING RUBBERFRONT SUSPENSION
SUBFRAME FRONT BRACKETFRONT SUSPENSION
SUBFRAMEFRONT SUSPENSION
SUBFRAME REAR BRACKETAPPROPRIATE
LINESBottom view:FRONT SUSPENSION
SUBFRAME
REAR BRACKETSUBFRAMETo
body.To body.To body.
Rear Subframe Torque
After removing the subframe mounting bolts, be sure to replace them with new ones.
REAR SUSPENSIONSUBFRAMESPECIAL BOLT
14 x 1.5 mm
103 N·m (10.5 kgf·m,
76 lbf·ft)
Replace.REAR SUSPENSION
SUBFRAME SPECIAL BOLT
14 x 1.5 mm
103 N·m (10.5 kgf·m, 76 lbf·ft)
Replace.To body.To body.INSTALLATION
REFERENCE HOLEINSTALLATION
REFERENCE HOLEINSTALLATION
REFERENCE HOLESUBFRAME Reference hole alignment: