Sunroof Limit Switch Adjustment (4D)

Sunroof Limit Switch Adjustment

1.	Remove the headliner.

2.	With the sunroof wrench, close the glass (A) fully: Make sure both link lifters (B) are parallel, and in the position shown. Check the glass fit to the roof panel and the glass height. BAFEDFEC 5 x 0.8 mm 5 N·m (0.5 kgf·m, 4 lbf·ft)

3.	With an open-end wrench, loosen the limit switch mounting bolts (C).

4.	Adjust the limit switch (D): Move the switch plate (E) a little at a time, then secure it at the position where you hear a faint click when the switch cam (F) pushes the upside limit switch (open/close). Check that the switch plate contacts the switch bracket (F).

5.	Check the operation of the glass (from the tilt-up position to fully closed position, from the fully open position to the fully closed position) by operating the sunroof switch.