Rear Lower Arm A Replacement (5D)

Rear Lower Arm A Replacement

1.	Raise the rear of the vehicle, and support it with safety stands in the proper locations.

2.	Remove the rear wheel.

3.	Remove the lower arm A mounting nut (B) and washer (C). B 12 x 1.25 mm 74 N·m (7.5 kgf·m, 54 lbf·ft)D 14 x 1.5 mm 93 N·m (9.5 kgf·m, 69 lbf·ft)CA

4.	Remove the lower arm A mounting bolt (D), and remove the lower arm A.

Install the lower arm A in the reverse order of removal, and note these items:

Use a new mounting nut on reassembly.
Tighten all mounting hardware to the specified torque values.
Before installing the wheel, clean the mating surfaces of the drum in brake disc and the inside of the wheel.
Check the wheel alignment, and adjust it if necessary.