Honda Accord ESM 2003 · Service Manual Service Manual 2003

Driveshaft Dynamic Damper Replacement (5D)

Driveshaft Dynamic Damper Replacement

1.Remove the inboard joint.

2.Remove the dynamic damper bands. Be careful not to damage the dynamic damper.

  • If the band is a welded type, cut the band.
  • If the band is a double loop type, lift up the band bend, and push it into the clip.
  • If the band is a low profile type, pinch the band using a commercially available boot band pincers.

3.Wrap the splines on the driveshaft with vinyl tape (A) to prevent damage to the dynamic damper.

Right driveshaft

SEA3E00E16226622502KBAD01A

Left driveshaft

SEA3E00E16226622502KBAD02A

4.Remove the dynamic damper. Be careful not to damage the dynamic damper.

5.Adjust the position of the new dynamic damper to the figure follow.

SEA3E00E16226622502KBAD03Right Driveshaft: 268-272 mm (10.55-10.71 in.)

SEA3E00E16226622502KBAD04Left Driveshaft: 288-292 mm (11.34-11.50 in.)

6.Install the dynamic damper band.

7.Install the inboard joint.