Interior Trim Removal/Installation - Rear Side Area (5D)

Interior Trim Removal/Installation - Rear Side Area

NOTE:

• Put on gloves to protect your hands.
  
• When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
  
• Take care not to bend or scratch the trim and panels.
  

1.	Remove these items: Trunk floor lid and both trunk side lids Front cargo floor Rear trim panel Rear floor box Rear door sill trim

2.	Remove the trim as shown:

3.

Install the trim in the reverse order of removal, and note these items: Replace any damaged clips. Make sure the trunk compartment light connector and rear accessory power socket connector are plugged in properly. Fastener LocationsA: Clip, 1B: Clip, 5C: Clip, 1TONNEAU COVERREAR SIDE TRIM PANELHOOKSWOOFER LID (Right side, with premium sound system)HOLDER BRACKET SIDE COVER Detach.TRUNK SIDE LID (Without premium sound system: Both sides With premium sound system: Left side)REAR FLOOR SIDE BOXCLIPBBBBBCA Fastener LocationsA: Clip, 2B: Clip, 10REAR DOOR OPENING TRIMHOOKSHOOKSQUARTER PILLAR TRIMCARGO AREA LIGHT CONNECTOR Disconnect.REAR ACCESSORY POWER SOCKET CONNETOR (Right side) Disconnect.HOOKHOOKHOOKSSCREWREAR SIDE TRIM PANELTIE-DOWN HOOK 6 x 1.0 mm 9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)REAR CARGO FLOOR SUPPORT6 x 1.0 mm 9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)SCREWLID SUPPORT BRACKETBBBBBAABBBBB(1)(2)