Inner Glove Box Removal/Installation

Inner Glove Box Removal/Installation

SRS components are located in this area. Review the SRS component locations, and the precautions and procedures in the SRS section before performing repairs or service.

NOTE:

• When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
  
• Take care not to scratch the dashboard and related parts.
  
• LHD is shown, RHD is symmetrical.
  

1.	Open the glove box lid.

2.	Gently pull out the inner glove box (A) to detach the clips, then remove it.   : Clip, 6Fastener LocationsCAB

3.	Install the glove box in the reverse order of removal. Insert a rib (B) on back of the box to the holder (C) of the steering hanger beam.