CVT Control Shaft Removal/Inspection (CVT)
CVT Control Shaft Removal/Inspection
| 1. | Remove the bolt (A) and lock washer (B), then remove the control lever (C) from the control shaft (D).
 DECA6 x 1.0 mm 14 N·m (1.4 kgf·m, 10 lbf·ft)B |
| 2. | Remove the control shaft from the transmission housing. |
| 3. | Check for fluid leaks between the housing and oil seal (E). If there is a fluid leak, replace the oil seal with a new one. |
| 4. | Install the control shaft in the transmission housing, and install the control lever on the control shaft. |
| 5. | Install the lock bolt with the new lock washer. |