DTC Troubleshooting: P1894 (38-1) (CVT)
DTC Troubleshooting: P1894 (38-1)
| DTC P1894: | Problem in CVT Speed Change Control Valve Circuit |
NOTE: Record all freeze data before you troubleshoot.
| 1. | Disconnect CVT speed change control valve connector. |
| 2. | Measure the resistance between connector terminals at the control valve connector.
 CVT SPEED CHANGE CONTROLVALVE CONNECTORTerminal side of male terminals Is the resistance 3.8-6.8 W? YES - Go to 3. NO - Faulty the CVT speed change control valve, replace the control valve body.n |
| 3. | Disconnect the battery negative terminal. |
| 4. | Disconnect PCM connectors B (24P) and C (22P). |
| 5. | Check for continuity between PCM connector terminal B24 and body ground, and between terminal C16 and body ground.
 Wire side of female terminalsPCM CONNECTORSC (22P)B (24P)DR LS+ (BLU/WHT)DR LS- (GRN/YEL)Are there continuity? YES - Repair short to ground in the wire between PCM connector terminal B24 and the CVT speed change control valve connector, and between terminal C16 and the CVT speed change control valve connector.n NO - Go to 6. |
| 6. | Reconnect CVT speed change control valve connector. |
| 7. | Measure the resistance between PCM connector terminals B24 and C16.
 Wire side of female terminalsPCM CONNECTORSC (22P)B (24P)DR LS+ (BLU/WHT)DR LS- (GRN/YEL)Is the resistance 3.8-6.8 W? YES - Check for loose terminal fit in the PCM connectors. If necessary, substitute a known-good PCM and recheck.n NO - Repair loose terminal or open in the wires between PCM connector terminals B24 and C16, and the CVT speed change control valve connector.n |