Honda Jazz/Fit 2003 · Service Manual

Wiper/Washer Switch Test/Replacement

Wiper/Washer Switch Test/Replacement

1.Remove the steering column covers.

2.Disconnect the 14P connector (A) from the wiper/washer switch (B).

LHD type and KE model: 

SAA2E00J54300065801FHAD01AB

RHD type except KE: 

SAA2E00J54300065801FHAD02BA

3.Remove the two screws, then pull out the wiper/washer switch.

4.Inspect the connector terminals to be sure they are all making good contact.

  • If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
  • If the terminals look OK, check for continuity between the terminals in each switch position according to the tables.
    • If there is no continuity, replace the switch.

Windshield : 

SAA2E00J54300065801FHAD03TerminalPositionOFFINTLOHIMist switch ONWasher switch ON4 [3]5 [2]6 [1]11 [10]12 [9]14 [7]

Rear window: 

SAA2E00J54300065801FHAD04TerminalPositionOFFWiper and Washer
switch ON1 [6]2 [5]3 [4]7 [14]ONWasher switch ON and
wiper switch OFF[ ] : RHD type except KE

The wiper switch is combined with the windshield wiper intermittent control circuit, so that you cannot isolate the No. 9 terminal to check it. Instead, do the input test at this connector terminal on page 22-160. If the input test is OK, but the windshield wiper intermittent function has failure; the switch must be faulty.