Center Console Removal/Installation

Center Console Removal/Installation

NOTE:

• When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
  
• Take care not to scratch the front seat, dashboard, and related parts.
  

1.	Remove the parking brake cover lid (A).   A

2.	M/T: Remove the shift knob.

3.

Remove the center console (A): -1  Remove the screws (B), and clips (C). -2  Lift the rear of the console up to detach the clip (D), and pull the console rearward to release the front hook (E) from the heater unit. -3  Disconnect the cigarette lighter connector (F).   GHFastener LocationsB: Screw, 2C: Clip, 2D: Clip, 1CECFBDB(1)(2)

4.	Install the console in the reverse order of removal, and note these items: Replace any damaged clips. Make sure the wire harness is not pinched. Set the rib (G) under the pocket onto the parking brake lever bracket (H) correctly.