DTC Troubleshooting: P1882 (33-1) (L15A CVT)
DTC Troubleshooting: P1882 (33-1)
| DTC P1882: | Problem in Inhibitor Solenoid Circuit |
NOTE: Record all freeze data before you troubleshoot.
| 1. | Disconnect the inhibitor solenoid connector. |
| 2. | Measure the resistance between connector terminals at the solenoid connector.
 INHIBITOR SOLENOID CONNECTORTerminal side of male terminalsIs the resistance 17.1-21.0 W? YES - Go to 3. NO - Replace the inhibitor solenoid.n |
| 3. | Disconnect the battery negative terminal. |
| 4. | Disconnect PCM connector C (22P). |
| 5. | Check for continuity between PCM connector terminal C6 and body ground.
 SOL INH (GRN/BLK)Wire side of female terminalsPCM CONNECTOR C (22P)Is there continuity? YES - Repair short to ground in the wire between PCM connector terminal C6 and the inhibitor solenoid.n NO - Go to 6. |
| 6. | Connect the inhibitor solenoid connector. |
| 7. | Disconnect PCM connector A (31P). |
| 8. | Measure the resistance between PCM connector terminals C6 and A4 or A5.
 PG2 (BLK)A (31P)C (22P)PG1 (BLK)SOL INH (GRN/BLK)PCM CONNECTORSWire side of female terminalsIs the resistance 17.1-21.0 W? YES - Update the PCM if it does not have the latest software, or subsutitute a known-good PCM, then recheck. If the symptom/ indication goes away with a known-good PCM, replace the original PCM.n NO - Repair loose terminals or open in the wire between PCM connector terminals C6, A4 or A5 and the inhibitor solenoid.n |