Rear Hub Bearing Unit Replacement - Rear Disc Brake
Rear Hub Bearing Unit Replacement - Rear Disc Brake
Exploded View-Disc Brake
20 x 1.5 mm162 N·m
(16.5 kgf·m, 119 lbf·ft)Apply a small amount
of engine oil to the seating
surface of the nut.SPINDLE NUT
Replace.REAR BEAM6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)SPLASH GUARD
Check for corrosion,
deformation,
and damage.
Replace if rusted.SPINDLE
Check for bend and deformation.10 x 1.25 mm
64 N·m
(6.5 kgf·m, 47 lbf·ft)HUB BEARING UNIT
Check for faulty movement
and wear.BRAKE DISCFLAT SCREW
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)HUB CAP
Replace.
Hub Replacement-Disc Brake
| 1. | Raise the rear of the vehicle, and support it with safety stands in the proper locations. |
| 2. | Remove the wheel nuts and rear wheel.
 108 N·m(11.0 kgf·m, 79.6 lbf·ft) |
| 3. | Remove the brake caliper bracket mounting bolts (A), and remove the caliper assembly (B) from the spindle. To prevent damage to the caliper assembly or brake hose, use a short piece of wire to hang the caliper assembly from the undercarriage. Do not twist the brake hose with force.
 A10 x 1.25 mm 55 N·m (5.6 kgf·m, 41 lbf·ft)B |
| 4. | Remove the hub cap (A).
 BAC20 x 1.5 mm 162 N·m (16.5 kgf·m, 119 lbf·ft) |
| 5. | Raise the stake (B), and remove the spindle nut (C). |
| 6. | Remove the 6 mm brake disc retaining screws (A).
 A6 x 1.0 mm 9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)B 8 x 1.25 mmC |
| 7. | Screw two 8 x 1.25 mm bolts (B) into the disc to push it away from the hub. Turn each bolt two turns at a time to prevent cocking the disc excessively. |
| 8. | Remove the brake disc (C). |
| 9. | Remove the hub bearing unit (A).
 A |
| 10. | Install the hub bearing unit in the reverse order of removal, and note these items:
|