Rack Guide Adjustment
Special Tools Required
Locknut wrench, 40 mm ( 07MAA-SL00100)
| 1. | Set the wheels in the straight ahead position.
|
| 2. | Loosen the rack guide screw locknut (A) with the special tool, then remove the rack guide screw (B).
LHD:  AB07MAA-SL00100RHD:  AB07MAA-SL00100 |
| 3. | Remove the old sealant from rack guide screw, and apply new sealant all around the threads (A).
 A |
| 4. | Loosely install the rack guide screw (A) on the steering gearbox.
 ACBManufactured in except HATC:
59 N·m (6.0 kgf·m, 43 lbt·ft)
Manufactured in HATC:
44 N·m (4.5 kgf·m, 33 lbt·ft) |
| 5. | Tighten the rack guide screw to 25 N·m (2.5 kgf·m, 18 lbf·ft), then loosen it.
|
| 6. | Retighten the rack guide screw to 3.9 N·m ( 0.4 kgf·m, 2.9 lbf·ft) then back it off to specified angle.
| Specified return angle (C): | | Manufactured in except HATC: | 7°-10° max. | | Manufactured in HATC: | 5°±2° |
|
| 7. | Tighten the locknut (B) while holding the rack guide screw (A).
|
| 8. | Check for unusual steering effort through the complete turning travel.
|
