Honda Jazz/Fit 2005 · Service Manual

Front Seat Belt Replacement

Front Seat Belt Replacement

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.

NOTE: Check the front seat belts for damage, and replace them if necessary.

Front Seat Belt


1.Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.

2.Slide the front seat forward fully.

3.Remove the lower anchor bolt (A).

 

SAA4EQ0H46200053401KBAD01A
7/16-20 UNF
32 N·m (3.3 kgf·m, 24 lbf·ft)

4.For some models: Detach the hooks (A), and release the hooks (B), then remove the center pillar lower trim cover (C). Disconnect the lap out tensioner connector (D), and remove the lower anchor bolt (E).

 

SAA4EQ0H46200053401KBAD027/16-20 UNF
32 N·m
(3.3 kgf·m, 24 lbf·ft)AADBBC

5.Remove the center pillar lower trim, with lap outer tensioner, without lap outer tensioner.

6.Remove the upper anchor cover (A), and remove the upper anchor bolt (B).

 

SAA4EQ0H46200053401KBAD03B
7/16-20 UNF
32 N·m (3.3 kgf·m, 24 lbf·ft)A

7.Disconnect the seat belt tensioner connector (A). Remove the upper retractor mounting self-tapping ET screw (B), and the lower retractor bolt (C), then remove the front seat belt (D) and retractor (E).

 

SAA4EQ0H46200053401KBAD04ForwardAC
7/16-20 UNF
32 N·m (3.3 kgf·m,
24 lbf·ft)B
5 x 0.8
4 N·m (0.4 kgf·m,
3 lbf·ft)

8.Remove the center pillar upper trim.

9.Remove the shoulder anchor adjuster (A).

 

SAA4EQ0H46200053401KBAD058 x 1.25 mm
22 N·m
(2.2 kgf·m, 16 lbf·ft)A

10.Install the seat belt in the reverse order of removal, and note these items:

  • Apply liquid thread lock to the upper anchor bolt before reinstallation.
  • Check that the retractor locking mechanism functions.
  • Follow the Anchor Bolt Installation diagrams carefully when assembling the washers, collars, and bushings of the upper and lower anchor bolts.
  • Before installing the anchor bolts, make sure there are no twists or kinks in the seat belt.
  • Make sure the seat belt tensioner connector and the lap outer tensioner connector (for some models) are plugged in properly.
  • Reconnect the negative cable to the battery.

Upper anchor bolt installation 

SAA4EQ0H46200053401KBAD06COLLARUPPER ANCHORUPPER ANCHOR
BOLTBUSHINGTOOTHED
LOCK WASHER

Lower anchor bolt installation 

SAA4EQ0H46200053401KBAD07COLLARWASHERLOWER ANCHOR BOLTCOLLARTOOTHED
LOCK WASHERLOWER ANCHORBUSHING

Lower anchor bolt installation (with lap outer tensioner) 

SAA4EQ0H46200053401KBAD08COLLARSPRING WASHERLOWER ANCHOR BOLTTOOTHED
LOCK WASHERLOWER ANCHORCOLLARS