Combination Light Switch Test/Replacement

1.	Remove the steering column covers.

2.	Disconnect the 16P connector (A) from the combination light switch (B). LHD type and KE model: AB RHD type except KE model: AB

3.	Remove the two screws, then slide out the combination light switch.

Inspect the connector terminals to be sure they are all making good contact.

If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
If the terminals look OK, check for continuity between the terminals in each switch position according to the tables.

TerminalPositionHeadlight switch46 [2]12Passing switchOFFLOWHIGHOFFON7 [1]13 [11]Light Switch:Turn Light Switch:Front and Rear Fog Light Switch:Front Fog Light Switch (Without RearFog Light):Rear Fog Light Switch (Without Front Fog Light):TerminalPositionTerminalPositionTerminalPositionTerminalPositionLEFTNEUTRALRIGHTOFFFront Fog
Light ONRear Fog
Light ONFront and Rear
Fog Light ONONOFFONOFF2 [13]10 [14]11 [6]1415169101516[ ]: RHD type except KE

5.	If there is no continuity, replace the switch.