7-speed Mode Main Switch Test
For KB, KE, KG, and KQ (L15A1 engine) Models (6-position CVT+7Speed Mode)
SRS components are located in this area. Review the following articles in the SRS before performing repairs or service;
| 2. | Check the 7SPEED MODE main switch for continuity between cable reel subharness 13P connector terminals No. 8 and No. 9.
There should be toggled continuity and no continuity between terminals every time the main switch pushes.
 Wire side of
female terminals |
| 3. | 7SPEED MODE main switch test has finished if the test result is OK.
If the main switch works incorrectly at the 13P connector, test the switch at the switch connector.
|
| 4. | Remove the screws (A) (4) securing the steering wheel rear cover (B), then remove the steering wheel rear cover.
 ABCDEFA |
| 5. | Remove steering shift + (plus) switch connector from its clamp, then disconnect the connector.
|
| 6. | Remove the screw (C) securing the steering shift + (plus) switch (D), then remove the switch.
|
| 7. | Disconnect 7SPEED MODE main switch connector (E), and remove the 7SPEED MODE main switch assembly (F).
|
| 8. | Check the 7SPEED MODE main switch for continuity between the switch connector terminals No. 5 and No. 6.
There should be toggled continuity and no continuity between terminals every time the main switch pushes.
|