ENTRY AND START SYSTEM (for Start Function) > Power Source Mode does not Change to ON (READY)

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

CHECK HYBRID CONTROL SYSTEM READY ON

CHECK FOR DTC

CHECK FOR DTC

CHECK POWER SOURCE CONDITION

READ VALUE USING INTELLIGENT TESTER (STOP LIGHT SWITCH ASSEMBLY)

READ VALUE USING INTELLIGENT TESTER (L CODE)

READ VALUE USING INTELLIGENT TESTER (ENGINE START REQUEST)

READ VALUE USING INTELLIGENT TESTER (S CODE)

CHECK ID CODE BOX (IMMOBILISER CODE ECU)

READ VALUE USING INTELLIGENT TESTER

INSPECT STOP LIGHT SWITCH ASSEMBLY

CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - STOP LIGHT SWITCH ASSEMBLY)

REPLACE TRANSMISSION CONTROL ECU ASSEMBLY

CHECK HYBRID CONTROL SYSTEM READY ON

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

CHECK HYBRID CONTROL SYSTEM READY ON