REAR SPEED SENSOR > INSTALLATION

1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

2. CONNECT REAR SPEED SENSOR WIRE

3. INSPECT REAR AXLE HUB BEARING LOOSENESS

4. INSPECT REAR AXLE HUB RUNOUT

5. INSTALL REAR DISC

6. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

7. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

8. INSTALL PARKING BRAKE LEVER PROTECTOR

9. INSTALL REAR SUSPENSION ARM COVER

10. ADJUST PARKING BRAKE

11. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for LHD)

12. INSTALL INSTRUMENT SIDE PANEL LH (for LHD)

13. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH (for LHD)

14. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)

15. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY (for RHD)

16. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)

17. INSTALL REAR WHEEL

18. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

19. CHECK FOR SPEED SENSOR SIGNAL