HYBRID VEHICLE TRANSAXLE > INSTALLATION

1. INSTALL MOTOR CABLE BRACKET

2. INSTALL WIRE HARNESS CLAMP BRACKET

3. INSTALL REAR ENGINE MOUNTING BRACKET

4. INSTALL FRONT ENGINE MOUNTING BRACKET

5. SUPPORT HYBRID VEHICLE TRANSAXLE ASSEMBLY

6. INSTALL HYBRID VEHICLE TRANSAXLE ASSEMBLY

7. INSTALL ENGINE MOUNTING BRACKET LH

8. INSTALL REAR ENGINE MOUNTING INSULATOR

9. INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY

10. INSTALL FRONT ENGINE MOUNTING INSULATOR

11. INSTALL FRONT CROSSMEMBER SUB-ASSEMBLY

12. INSTALL FRONT SUSPENSION MEMBER REAR BRACE LH

13. INSTALL FRONT SUSPENSION MEMBER REAR BRACE RH

14. INSTALL REAR SIDE RAIL REINFORCEMENT SUB-ASSEMBLY LH

15. INSTALL REAR SIDE RAIL REINFORCEMENT SUB-ASSEMBLY RH

16. INSTALL FRONT ENGINE MOUNTING BRACKET LOWER REINFORCEMENT

17. INSTALL FLYWHEEL HOUSING SIDE COVER

18. INSTALL STARTER HOLE INSULATOR

19. REMOVE ENGINE HANGERS

20. INSTALL FRONT DRIVE SHAFT HOLE SNAP RING LH

21. INSTALL FRONT DRIVE SHAFT HOLE SNAP RING RH

22. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH

23. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH

24. CONNECT FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH

25. CONNECT FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH

26. INSTALL FRONT STABILIZER LINK ASSEMBLY LH

27. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

28. CONNECT TIE ROD END SUB-ASSEMBLY LH

29. CONNECT TIE ROD END SUB-ASSEMBLY RH

30. INSTALL FRONT SPEED SENSOR LH

31. INSTALL FRONT SPEED SENSOR RH

32. INSTALL FRONT AXLE SHAFT NUT LH

33. INSTALL FRONT AXLE SHAFT NUT RH

34. INSTALL FRONT EXHAUST PIPE ASSEMBLY (w/ Exhaust Heat Recirculation System)

35. INSTALL FRONT EXHAUST PIPE ASSEMBLY (w/o Exhaust Heat Recirculation System)

36. INSTALL FRONT CENTER FLOOR BRACE

37. INSTALL FRONT NO. 3 ENGINE UNDER COVER

38. CONNECT NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY

39. CONNECT NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY

40. INSTALL COLUMN HOLE COVER SILENCER SHEET

41. INSTALL WIRE HARNESS

42. CONNECT NO. 5 INVERTER COOLING HOSE

43. CONNECT NO. 3 INVERTER COOLING HOSE

44. INSTALL RADIATOR PIPE

45. CONNECT NO. 4 WATER BY-PASS HOSE

46. CONNECT NO. 1 RADIATOR HOSE

47. INSTALL INVERTER TRAY BRACKET

48. INSTALL INVERTER RESERVE TANK ASSEMBLY

49. INSTALL INVERTER WITH CONVERTER ASSEMBLY

50. CONNECT WATER HOSE

51. CONNECT NO. 2 ENGINE ROOM WIRE

52. REMOVE INVERTER COVER

53. CONNECT NO. 2 ENGINE WIRE

54. CONNECT MOTOR CABLE

55. CONNECT GENERATOR CABLE

56. CONNECT FRAME WIRE

57. CHECK HIGH VOLTAGE CABLE CONNECTION

58. INSTALL INVERTER COVER

59. CONNECT ENGINE ROOM MAIN WIRE

60. INSTALL NO. 1 INVERTER BRACKET

61. INSTALL AIR CLEANER HOSE ASSEMBLY

62. INSTALL AIR CLEANER CASE

63. INSTALL INLET AIR CLEANER

64. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

65. INSTALL SERVICE PLUG GRIP

66. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

67. INSTALL REAR FLOOR BOARD UPPER NO. 3 PLATE

68. INSTALL DECK FLOOR BOX RH

69. INSTALL REAR NO. 3 FLOOR BOARD

70. INSTALL REAR DECK FLOOR BOX

71. INSTALL REAR NO. 2 FLOOR BOARD

72. ADD HYBRID TRANSAXLE FLUID

73. ADD COOLANT (for Inverter)

74. ADD COOLANT (for Engine)

75. INSPECT HYBRID TRANSAXLE FLUID

76. INSPECT FOR COOLANT LEAK (for Inverter)

77. INSPECT FOR COOLANT LEAK (for Engine)

78. INSPECT FOR EXHAUST GAS LEAK

79. INSTALL NO. 1 ENGINE UNDER COVER

80. INSTALL FRONT LOWER BUMPER ABSORBER

81. INSTALL REAR ENGINE UNDER COVER LH

82. INSTALL REAR ENGINE UNDER COVER RH

83. INSTALL FRONT WHEEL

84. INSTALL HOOD SUB-ASSEMBLY

85. INSPECT HOOD SUB-ASSEMBLY

86. ADJUST HOOD SUB-ASSEMBLY

87. INSTALL SUSPENSION TOWER DAMPER

88. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)

89. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)

90. INSTALL COWL BODY MOUNTING REINFORCEMENT LH (for LHD)

91. INSTALL COWL BODY MOUNTING REINFORCEMENT RH (for RHD)

92. INSTALL NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL (for LHD)

93. INSTALL NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL (for RHD)

94. INSTALL NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL (for LHD)

95. INSTALL NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL (for RHD)

96. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

97. INSTALL NO. 2 CYLINDER HEAD COVER

98. INSTALL RADIATOR SUPPORT OPENING COVER

99. INSTALL INVERTER COVER ASSEMBLY LH (w/ Cover)

100. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

101. CHECK ABS SPEED SENSOR SIGNAL