FRONT LOWER BALL JOINT > INSTALLATION

for Preparation Click here

HINT:

1. Use the same procedure for the RH side and LH side.
   
2. The procedure listed below is for the LH side.
   

1. Secure the front axle assembly in a vise.
   

   NOTICE:

   When using a vise, do not overtighten it.

2. Install the front lower ball joint assembly to the front axle assembly with the nut.
   

   Torque:

   71 N*m{ 724 kgf*cm , 52 ft.*lbf }

3. Install a new clip.
   

   NOTICE:

   Further tighten the nut up to 60° if the holes for the clip are not aligned.