FRONT CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL RH


2. REMOVE REAR ENGINE UNDER COVER RH


3. REMOVE REAR SIDE RAIL REINFORCEMENT SUB-ASSEMBLY RH

HINT:
Perform the same procedure as for the LH side.



4. REMOVE CRANKSHAFT PULLEY


    A213052E02

  1. Using SST, hold the pulley in place and loosen the pulley bolt.
    Text in Illustration 
    *a
    		Hold
    *b
    		Turn

    SST
    09213-58014   (91551-80840)
    09330-00021  



    A213053E02

  1. Using SST, remove the crankshaft pulley and pulley bolt.
    Text in Illustration 
    *a
    		Hold
    *b
    		Turn

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)



5. REMOVE TIMING CHAIN COVER OIL SEAL


    A112529E06

  1. Using a knife, cut off the lip of the oil seal.
    Text in Illustration 
    *1
    		Protective Tape
    *a
    		Cut Position

  1. Using a screwdriver with its tip wrapped with tape, pry out the oil seal.

    NOTICE:
    After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.