FRONT BRAKE > DISASSEMBLY

for Preparation Click here



1. REMOVE CYLINDER BOOT


    C205539E01

  1. Using a screwdriver with its tip wrapped with vinyl tape, remove the set ring and cylinder boot from the disc brake cylinder assembly.
    Text in Illustration 
    *1
    		Vinyl Tape

    NOTICE:
    Be careful not to damage the brake piston or cylinder.



2. REMOVE FRONT DISC BRAKE PISTON


    C205540

  1. Place a piece of cloth between the front disc brake piston and disc brake cylinder assembly.

  1. Apply compressed air to remove the front disc brake piston from the disc brake cylinder assembly.

    CAUTION:
    Do not place your fingers in front of the piston when using compressed air.

    NOTICE:
    Do not allow any brake fluid to spatter.



3. REMOVE PISTON SEAL


    C116884E06

  1. Using a screwdriver with its tip wrapped with vinyl tape, remove the piston seal from the disc brake cylinder assembly.
    Text in Illustration 
    *1
    		Vinyl Tape

    NOTICE:
    Do not damage the inner surface or piston seal groove of the cylinder.



4. REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP


5. REMOVE FRONT DISC BRAKE BLEEDER PLUG