WIPER AND WASHER SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



ACTIVE TEST (w/ Headlight Cleaner System)

HINT:
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Main Body / Active Test.

  5. Perform the Active Test according to the display on the intelligent tester.

    Main Body 
    Tester Display
    		Test Part
    		Control Range
    		Diagnostic Note
    Head Light Cleaner
    		Low beam headlight state signal
    		ON/OFF
    		-