LIGHTING SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Main Body / Data List.

  5. Read the Data List according to the display on the intelligent tester.

    Main Body 
    Tester Display
    		Measurement Item/Range
    		Normal Condition
    		Diagnostic Note
    ACC SW
    		Power switch ACC signal/ON or OFF
    		ON: Power switch on (ACC)
    OFF: Power switch off
    		-
    IG SW
    		Power switch IG signal/ON or OFF
    		ON: Power switch on (IG)
    OFF: Power switch off
    		-
    RR Door Courtesy SW
    		Rear door courtesy light switch RH signal/ON or OFF
    		ON: Rear door RH open
    OFF: Rear door closed
    		-
    RL Door Courtesy SW
    		Rear door courtesy light switch LH signal/ON or OFF
    		ON: Rear door LH open
    OFF: Rear door LH closed
    		-
    Back door Courtesy SW
    		Back door courtesy light switch signal/ON or OFF
    		ON: Back door open
    OFF: Back door closed
    		-
    FR Door Lock Pos
    		Front door unlock detection switch RH signal/ON or OFF
    		ON: Front door RH unlocked
    OFF: Front door RH locked
    		-
    FR Door Courtesy
    		Front door RH condition signal/ON or OFF
    		ON: Front door RH closed
    OFF: Front door RH open
    		-
    FL Door Lock Pos
    		Front door unlock detection switch LH signal/ON or OFF
    		ON: Front door LH unlocked
    OFF: Front door LH locked
    		-
    FL Door Courtesy
    		Front door LH condition signal/ON or OFF
    		ON: Front door LH closed
    OFF: Front door LH open
    		-
    RR-Door Lock Pos SW
    		Rear door unlock detection switch RH signal/ON or OFF
    		ON: Rear door RH unlocked
    OFF: Rear door RH locked
    		-
    RL-Door Lock Pos SW
    		Rear door unlock detection switch LH signal/ON or OFF
    		ON: Rear door LH unlocked
    OFF: Rear door LH locked
    		-
    Interior Light Control
    		Operation of the illuminated entry system/OFF or ON
    		OFF: The system not operated
    ON: The system operated
    		Customized value displayed
    I/L ON W/Door Key Unlock
    		Setting of the function that lights up the interior lights when the doors are unlocked/OFF or ON
    		OFF: The function not provided
    ON: The function provided
    		Customized value displayed
    Lighting Time
    		Lighting time of the delay control function (illuminated entry system)/15s, 7.5s or 30s
    		15s: 15 seconds
    7.5s: 7.5 seconds
    30s: 30 seconds
    		Customized value displayed
    Room Light when Aprchd
    		Setting of the function that lights up the interior lights when a key enters any actuation area/OFF or ON
    		OFF: The function not provided
    ON: The function provided
    		Customized value displayed
    Inside Foot Light
    		Setting of the function that lights up the footwell lights (Always)/OFF or ON
    		OFF: The function not provided
    ON: The function provided
    		Customized value displayed
    Center Console Spot Light
    		Setting of the function that lights up the center console spot light/OFF or ON
    		OFF: The function not provided
    ON: The function provided
    		Customized value displayed
    I/L when ACC OFF
    		Setting of the function that lights up the interior lights when the power switch on (ACC)/OFF or ON
    		OFF: The function not provided
    ON: The function provided
    		Customized value displayed
    Light Control
    		Setting of the function that lights up the footwell lights (while Driving)/OFF or ON
    		OFF: The function not provided
    ON: The function provided
    		Customized value displayed


ACTIVE TEST

HINT:
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Main Body or Entry&Start / Active Test.

  5. Perform the Active Test according to the display on the intelligent tester.

    Main Body 
    Tester Display
    		Test Part
    		Control Range
    		Diagnostic Note
    Illuminated Entry System
    		Front interior lights and rear interior light
    		ON/OFF
    		Interior light on/off switch off (not pushed), interior light door switch on (not pushed) and all doors closed
    Fr Foot Light
    		Footwell lights
    		ON/OFF
    		Power switch off
    Center Consol Spot LGT
    		Center console spot lights (red, blue)
    		ON/OFF
    		Power switch off

    Entry&Start 
    Tester Display
    		Test Part
    		Control Range
    		Diagnostic Note
    Power/Engine SW Light
    		Power switch illumination
    		ON/OFF
    		All doors closed