NAVIGATION SYSTEM (for DVD) > Route cannot be Calculated

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK MAP DISC


    I100152
  1. Check that the map disc is not deformed or cracked.

    OK:
    No deformations or cracks on the map disc



NG
REPLACE MAP DISC
OK


2.CHECK CABIN
  1. Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin.

    HINT:
    1. A humid cabin and a rapid change in temperature may lead to condensation. Condensation in the cabin may cause a short circuit.
    2. The navigation system may not operate normally when the temperature is -20°C (-4°F) or lower, or 65°C (149°F) or higher.

    OK:
    Condensation is not likely being produced and the temperature is not high or extremely low.



NG
CABIN TO APPROPRIATE TEMPERATURE
OK


3.SET DESTINATION
  1. Set another destination and check if the system can calculate the route correctly.

    OK:
    Route can be correctly calculated.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

NORMAL OPERATION