NAVIGATION SYSTEM (for HDD) > Voice is not Recognized

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK NAVIGATION SETTING


    E181035E02

  1. Display the "Voice Settings" screen.

  1. Check that "Voice Recognition Guidance" is not "Off".

    OK:
    "Voice Recognition Guidance" is not "Off".

Text in Illustration 
*a
Example


NG
TURN VOICE RECOGNITION GUIDANCE "On"
OK


2.CHECK MICROPHONE (OPERATION CHECK)


    E187218E09

  1. Enter the "Microphone & Voice Recognition Check" screen. Refer to Check Mic & Voice Recognition in Operation Check (Click here).

  1. When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

  1. Select the recording switch and perform voice recording.

    HINT:
    1. Select the recording switch with the blower motor of the air conditioning system stopped. If an outlet of the air conditioning system is facing the microphone, noise may be recorded.
    2. Voice can be recorded up to 5 seconds.

  1. Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

    OK:
    All check results are normal.

Text in Illustration 
*a
Microphone Input Level Meter
*b
Recording Switch
*c
Stop Switch
*d
Play Switch
*e
Recording Indicator


NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK


3.REPLACE HARD DISK DRIVE

  1. Replace the hard disk drive (Click here).

  1. Check that voice recognition is normal.

    OK:
    Voice can be recognized normally.



NG
REPLACE NAVIGATION COMPUTER SUB-ASSEMBLY (Click here)
OK

END