NAVIGATION SYSTEM (for HDD) > Vehicle Position Mark Deviates Greatly

for Preparation Click here


INSPECTION PROCEDURE

NOTICE:
  1. If standard size tires are not installed, the vehicle position mark may deviate from the route even if the navigation system is operating normally.
  2. Make sure that standard size tires are installed to the vehicle before inspection.

1.CHECK GPS MARK


    E181031E04

  1. Check that the GPS mark is displayed.

    OK:
    GPS mark is displayed.

Text in Illustration 
*a
Example


NG
GO TO "GPS MARK IS NOT DISPLAYED" IN PROBLEM SYMPTOMS TABLE (Click here)
OK


2.CHECK VEHICLE SIGNAL (OPERATION CHECK)

  1. Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal in Operation Check (Click here).



    E176550

  1. Check that the display changes between ON and OFF according to the shift state.

    OK:
    Shift State
    		Display
    Except R
    		OFF
    R
    		ON

    HINT:
    The display is updated once per second. It is normal for the display to lag behind the actual switch operation.



NG
GO TO "REVERSE SIGNAL DOES NOT CHANGE IN NAVIGATION CHECK MODE" IN PROBLEM SYMPTOMS TABLE (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)