NAVIGATION SYSTEM (for DVD) > Current Position Display does not Appear

for Preparation Click here

INSPECTION PROCEDURE

1. Enter the map data information screen.
   

2. Check if a disc is inserted into the map disc slot.
   

   1. Check if the map data version is displayed in the "Map Data" section.
      

      OK:

      The map data version is displayed.
      

      Text in Illustration 

      *a

      Example

NG	INSERT MAP DISC IN MAP SIDE SLOT

OK

1. Check that a map disc is inserted and that it is not deformed or cracked.
   

   OK:

   No deformations or cracks on the map disc
   

NG	REPLACE MAP DISC

OK

1. Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin.
   

   HINT:

   1. A humid cabin and a rapid change in temperature may lead to condensation. Condensation in the cabin may cause a short circuit.
      
   2. The navigation system may not operate normally when the temperature is -20°C (-4°F) or lower, or 65°C (149°F) or higher.
      

   OK:

   Condensation is not likely being produced and the temperature is not high or extremely low.
   

NG	CABIN TO APPROPRIATE TEMPERATURE

OK
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)