FUEL PUMP > DISASSEMBLY

for Preparation Click here

1. Disconnect the 3 harness clamps.
   

   NOTICE:

   Do not damage the wire harness.

2. Remove the 2 harness protectors from the wire harness.
   

   NOTICE:

   Do not damage the wire harness.

3. Disconnect the connector of the fuel sender gauge assembly.
   

4. Release the lock as shown in the illustration and slide the fuel sender gauge assembly to remove it.
   

1. Disconnect the connector of the fuel pump harness.
   

2. Disconnect the fuel pump filter hose.
   

3. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws, and remove the fuel filter and fuel pump from the fuel sub-tank.
   

   Text in Illustration 

   *1	Fuel Tube
   *2	Fuel Sub-tank

   NOTICE:

   Do not do anything which may separate the fuel tube from either the fuel suction plate or fuel filter assembly, such as applying excessive force to the tube (Click here).

4. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the No. 1 fuel suction support.
   

5. Using a screwdriver with its tip wrapped in protective tape, disengage the 5 claws, and remove the fuel pump from the fuel filter.
   

   Text in Illustration 

   *1	Fuel Filter
   *2	Suction Filter

   NOTICE:

   1. Do not damage the fuel filter.
      
   2. Do not remove the suction filter.
      
   3. Do not use either the fuel pump or the suction filter if the suction filter is removed from the fuel pump.
      

6. Disconnect the fuel pump harness connector.
   

7. Remove the O-ring and spacer from the fuel pump.
   

   Text in Illustration 

   *1	O-ring
   *2	Spacer
   *a	5.0 mm (0.197 in.)

   NOTICE:

   Be careful not to damage the sealing surface.

   HINT:

   If the O-ring still remains in the fuel filter, remove it using a wire tip (1 mm diameter) that is formed as shown in the illustration.