POWER MIRROR CONTROL SYSTEM (w/ Memory) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedure to troubleshoot the power mirror control system.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      HINT:
      1. In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
      2. Gather as much information as possible for reference.
        Past problems that seem unrelated may also help in some cases.
      3. The following 5 items are important points in the problem analysis:

        What
        		Vehicle model, system name
        When
        		Date, time, occurrence frequency
        Where
        		Road conditions
        Under what conditions?
        		Running conditions, driving conditions, weather conditions
        How did it happen?
        		Problem symptoms


    NEXT


    3.INSPECT AUXILIARY BATTERY VOLTAGE

      Standard Voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.

    NEXT


    4.CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*

    1. Use the intelligent tester to check if the LIN communication system is functioning normally.

      Result:

      Result
      		Proceed to
      LIN DTC is not output
      		A
      LIN DTC is output
      		B



    		B.
    Go to LIN COMMUNICATION SYSTEM (Click here)
    A


    5.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*

    1. Use the intelligent tester to check if the CAN communication system is functioning normally.

      Result:

      Result
      		Proceed to
      CAN DTC is not output
      		A
      CAN DTC is output
      		B



    		B.
    Go to CAN COMMUNICATION SYSTEM (Click here)
    A


    6.PROBLEM SYMPTOMS TABLE

    1. Refer to Problem Symptoms Table (Click here).

      Result:

      Result
      		Proceed to
      Fault is not listed in Problem Symptoms Table
      		A
      Fault is listed in Problem Symptoms Table
      		B



    		B.
    Go to step 8
    A


    7.OVERALL ANALYSIS AND TROUBLESHOOTING*

    1. Operation Check (Click here)

    2. Data List / Active Test (Click here)

    3. Terminals of ECU (Click here)


    NEXT


    8.REPAIR OR REPLACE

      NEXT


      9.CONFIRMATION TEST

        NEXT

        END