STEERING PAD > INSTALLATION

for Preparation Click here

1. Check that the power switch is off.
   

2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
   

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

3. Connect the 2 airbag connectors to the horn button assembly.
   

   NOTICE:

   1. When connecting any airbag connector, take care not to damage the airbag wire harness.
      
   2. Be sure to only connect the connectors to each corresponding color.
      

4. Push in the 2 locks to install the 2 airbag connectors.
   

5. Connect the horn connector to the horn button assembly.
   

6. Push the horn button assembly to engage the 3 pins.
   

   NOTICE:

   1. Make sure that the pins are securely inserted into the steering holes.
      
   2. Make sure to engage the 2 upper pins first.
      
   3. Make sure that the horn button assembly is securely installed.
      

1. Engage the claw to install the lower No. 3 steering wheel cover.
   

1. Engage the claw to install the lower No. 2 steering wheel cover.
   

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

1. Engage the 4 claws and 2 guides to install the rear floor board upper No. 3 plate.
   

1. Engage the 6 guides.
   

2. Install the deck floor box RH with the clip.
   

1. Install the rear No. 3 floor board.
   

1. Install the rear deck floor box.
   

1. Install the rear No. 2 floor board.
   

1. Make sure that the horn sounds.
   

   HINT:

   If the horn does not sound, inspect the horn system (Click here).