SPIRAL CABLE > REMOVAL

for Preparation Click here



1. REMOVE STEERING WHEEL ASSEMBLY
(Click here)


2. REMOVE STEERING COLUMN COVER

NOTICE:
Removing the steering column cover in the incorrect order will cause the parts to break.



    C233366

  1. Remove the 2 screws.



    C226620

  1. Push the right and left sides of the steering column cover (lower side) to disengage the 4 claws.



    C226621

  1. Insert fingers into the opening of the tilt lever of the steering column cover (lower side) to disengage the 2 claws and remove the steering column cover (lower side).

    HINT:
    Spread the claws to disengage them.



    C226624

  1. Disengage the 4 clips and 2 guides from the steering column cover (upper side).



    C226625

  1. Disengage the 2 claws to remove the steering column cover (upper side).



3. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

NOTICE:
  1. Do not replace the spiral cable with the auxiliary battery connected and the power switch on (IG).
  2. Do not rotate the spiral cable without the steering wheel with the auxiliary battery connected and the power switch on (IG).
  3. Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.
  4. Do not remove the steering sensor from the spiral cable.



    B232207E01

  1. Slide the slider to release the lock, and then disconnect the yellow airbag connector from the spiral cable with sensor sub-assembly.
    Text in Illustration 
    *1
    		Slider

    NOTICE:
    When disconnecting any airbag connector, take care not to damage the airbag wire harness.

  1. Disconnect the other connector from the spiral cable with sensor sub-assembly.



    B252856

  1. Disengage the 3 claws to remove the spiral cable with sensor sub-assembly.