KNEE AIRBAG ASSEMBLY (for Driver Side) > INSTALLATION

for Preparation Click here



1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

  1. Check that the power switch is off.

  1. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



    B252860

  1. Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.

    NOTICE:
    When connecting any airbag connector, take care not to damage the airbag wire harness.

  1. Push in the lock to install the airbag connector.

  1. Temporarily install the lower No. 1 instrument panel airbag assembly with the 6 claws and 3 guides.

  1. Install the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    NOTICE:
    Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.



2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
for LHD: (Click here)
for RHD: (Click here)


3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



4. INSTALL REAR FLOOR BOARD UPPER NO. 3 PLATE

  1. Engage the 4 claws and 2 guides to install the rear floor board upper No. 3 plate.



5. INSTALL DECK FLOOR BOX RH

  1. Engage the 6 guides.

  1. Install the deck floor box RH with the clip.



6. INSTALL REAR NO. 3 FLOOR BOARD

  1. Install the rear No. 3 floor board.



7. INSTALL REAR DECK FLOOR BOX

  1. Install the rear deck floor box.



8. INSTALL REAR NO. 2 FLOOR BOARD

  1. Install the rear No. 2 floor board.



9. PERFORM DIAGNOSTIC SYSTEM CHECK
(Click here)


10. INSPECT SRS WARNING LIGHT
(Click here)