KNEE AIRBAG ASSEMBLY (for Front Passenger Side) > INSTALLATION

for Preparation Click here


NOTICE:
  1. Use the same procedure for the front passenger side of RHD and LHD vehicles.
  2. The procedures listed below are for the front passenger side of an LHD vehicle.



1. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

  1. Check that the power switch is off.

  1. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



    B252863

  1. Connect the airbag connector to the lower No. 2 instrument panel airbag assembly.

    NOTICE:
    When connecting any airbag connector, take care not to damage the airbag wire harness.

  1. Push in the lock to install the airbag connector.

  1. Temporarily install the lower No. 2 instrument panel airbag assembly with the 6 claws and 2 guides.

  1. Install the 3 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    NOTICE:
    Confirm that the lower No. 2 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.



2. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:
Use the same procedure for the RH side and LH side (Click here).



3. INSTALL FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedure for the RH side and LH side (Click here).



4. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
for LHD: (Click here)
for RHD: (Click here)


5. INSTALL INSTRUMENT SIDE PANEL RH

  1. Connect the connector.



    B269870

  1. Engage the 4 guides, clip and 3 claws to install the instrument side panel RH.



6. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH


7. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



8. INSTALL REAR FLOOR BOARD UPPER NO. 3 PLATE

  1. Engage the 4 claws and 2 guides to install the rear floor board upper No. 3 plate.



9. INSTALL DECK FLOOR BOX RH

  1. Engage the 6 guides.

  1. Install the deck floor box RH with the clip.



10. INSTALL REAR NO. 3 FLOOR BOARD

  1. Install the rear No. 3 floor board.



11. INSTALL REAR DECK FLOOR BOX

  1. Install the rear deck floor box.



12. INSTALL REAR NO. 2 FLOOR BOARD

  1. Install the rear No. 2 floor board.



13. PERFORM DIAGNOSTIC SYSTEM CHECK
(Click here)


14. INSPECT SRS WARNING LIGHT
(Click here)