CURTAIN SHIELD AIRBAG ASSEMBLY > ON-VEHICLE INSPECTION

for Preparation Click here


CAUTION:
Be sure to correctly follow the removal and installation procedures for the curtain shield airbag assemblies.



1. INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY (for Vehicle not Involved in Collision)

  1. Perform a diagnostic system check (Click here).

  1. Visually check for defects with the curtain shield airbag assemblies installed on the vehicle.

    1. The defects are as follows:

      1. Cuts on each pillar garnish or the roof headlining assembly around the curtain shield airbag assemblies
      2. Small cracks on each pillar garnish or the roof headlining assembly around the curtain shield airbag assemblies
      3. Significant discoloration on each pillar garnish or the roof headlining assembly around the curtain shield airbag assemblies

      OK:
      No defects are found.

      HINT:
      If any of the defects is found, replace each pillar garnish or the roof headlining assembly with a new one.



2. INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)

  1. Perform a diagnostic system check (Click here).

  1. Visually check for defects with the curtain shield airbag assemblies removed from the vehicle.

    1. The defects are as follows:

      1. Cuts on the curtain shield airbag assemblies
      2. Small cracks on the curtain shield airbag assemblies
      3. Significant discoloration on the curtain shield airbag assemblies
      4. Cracks or other damage to the connector

      OK:
      No defects are found.

      HINT:
      If any of the defects is found, replace the curtain shield airbag assembly with a new one.