DYNAMIC RADAR CRUISE CONTROL SYSTEM > DTC CHECK / CLEAR

for Preparation Click here



CHECK DTC

  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Powertrain / Radar Cruise / DTC.

  5. Read the DTCs.


CLEAR DTC

  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Powertrain / Radar Cruise / DTC.

  5. Clear the DTCs.