DYNAMIC RADAR CRUISE CONTROL SYSTEM > FAIL-SAFE CHART |
| Constant speed control mode and vehicle-to-vehicle distance control mode: |
| Vehicle Condition | Auto Cancel Condition | Fail-safe Deactivation Condition |
|
| Cruise control switch is turned off and then on again |
| Vehicle-to-vehicle distance control mode: |
![]() |
| *1 | Multi-information Display |
| *2 | Master Warning Light |
| *3 | Cruise Control Indicator Light (Vehicle-to-vehicle distance control mode) |
| Vehicle Condition | Auto Cancel Condition | Fail-safe Deactivation Condition |
|
| Power switch turned off and then on (IG) again |
| Vehicle-to-vehicle distance control mode: |
![]() |
| *1 | Multi-information Display |
| *2 | Master Warning Light |
| *3 | Cruise Control Indicator Light (Vehicle-to-vehicle distance control mode) |
| Vehicle Condition | Auto Cancel Condition | Fail-safe Deactivation Condition |
| There is dirt on millimeter wave radar sensor |
|
|
|
| Constant speed control mode and vehicle-to-vehicle distance control mode: |
| Vehicle Condition | Auto Cancel Condition | Fail-safe Deactivation Condition |
| Cruise control indicator light on | Constant Speed Control Mode: Vehicle speed is lower than stored vehicle speed by 16 km/h (10 mph) or more while cruise control is operating | Push the cruise control switch to +/RES |
| Cruise control indicator light goes off |
| Power switch turned off then on (IG) again |
| Constant speed control mode and vehicle-to-vehicle distance control mode: |
| Vehicle Condition | Auto Cancel Condition | Fail-safe Deactivation Condition |
| Cruise control indicator light on | Vehicle speed is lower than low speed limit (approximately 40 km/h (25 mph)) while cruise control is operating | Push the cruise control switch to +/RES |
| Electronically controlled brake system operates | Cruise control is turned off and then on |