SIDE AIRBAG SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here


CAUTION:
Be sure to correctly follow the removal and installation procedures for the side airbag sensor assemblies.



1. INSPECT SIDE AIRBAG SENSOR ASSEMBLY (for Vehicle not Involved in Collision)

  1. Perform a diagnostic system check (Click here).



2. INSPECT SIDE AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)

  1. Perform a diagnostic system check (Click here).

  1. Visually check the side airbag sensor assemblies for defects if a center pillar of the vehicle or the area around a center pillar is damaged.

    1. The defects are as follows:

      1. Cracks on the sensor housing
      2. Dents on the sensor housing
      3. Chips on the sensor housing
      4. Cracks or other damage to the connector
      5. Damage to the serial number

      OK:
      No defects are found.

      HINT:
      If any of the defects is found, replace the side airbag sensor assembly with a new one.



3. INSPECT SIDE AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and Airbag is Deployed)

  1. When airbags have deployed as the result of a collision, be sure to replace all side airbag sensor assemblies in the damaged areas (anywhere in need of repair).

  1. Visually check the side airbag sensor assemblies in undamaged areas for defects.

    1. The defects are as follows:

      1. Cracks on the sensor housing
      2. Dents on the sensor housing
      3. Chips on the sensor housing
      4. Cracks or other damage to the connector
      5. Damage to the serial number

      OK:
      No defects are found.

      HINT:
      If any of the defects is found or a side airbag sensor assembly has detected a major collision, replace the side airbag sensor assembly with a new one.