BATTERY BLOWER > REMOVAL

for Preparation Click here



1. REMOVE REAR NO. 2 FLOOR BOARD

  1. Remove the rear No. 2 floor board.



2. REMOVE REAR DECK FLOOR BOX

  1. Remove the rear deck floor box.



3. REMOVE REAR NO. 3 FLOOR BOARD

  1. Remove the rear No. 3 floor board.



4. REMOVE DECK FLOOR BOX RH


    B270546

  1. Remove the clip.

  1. Disengage the 6 guides and remove the deck floor box RH.



5. REMOVE REAR NO. 4 FLOOR BOARD (w/o Woofer)

  1. Remove the rear No. 4 floor board.



6. REMOVE REAR NO. 4 FLOOR BOARD (w/ Woofer)


    B270548

  1. Disengage the 2 clips and 3 guides, and remove the rear No. 4 floor board.



7. REMOVE DECK FLOOR BOX LH (w/o Woofer)


    B270549

  1. Remove the clip.

  1. Disengage the 6 guides and remove the deck floor box LH.



8. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

  1. Remove the tonneau cover assembly.



9. REMOVE REAR NO. 1 FLOOR BOARD SUB-ASSEMBLY


    B270540

  1. Disengage the 2 claws and 2 clips, and remove the rear No. 1 floor board sub-assembly.



10. REMOVE REAR NO. 2 FLOOR BOARD SUB-ASSEMBLY


    B270541

  1. Disengage the claw and 2 clips, and remove the rear No. 2 floor board sub-assembly.



11. REMOVE REAR NO. 1 FLOOR BOARD


    B270542

  1. Remove the bolt.

  1. Disengage the 2 claws and 2 clips, and remove the rear No. 1 floor board.



12. REMOVE REAR SEATBACK ASSEMBLY RH
(Click here)


13. REMOVE REAR DOOR SCUFF PLATE RH

HINT:
Use the same procedure as for the LH side (Click here).



14. REMOVE REAR SEAT SIDE GARNISH RH

HINT:
Use the same procedure as for the LH side (Click here).



15. REMOVE REAR FLOOR BOARD SPACER


    A214691

  1. Remove the 2 clips and rear floor board spacer.



16. REMOVE NO. 1 HYBRID BATTERY INTAKE DUCT


    A247662

  1. Remove the 2 clips and No. 1 hybrid battery intake duct.



17. REMOVE BATTERY COOLING BLOWER ASSEMBLY

NOTICE:
  1. Be sure not to touch the fan part of the battery cooling blower assembly.
  2. Do not lift the battery cooling blower assembly using the wire harness.



    A247665

  1. Disconnect the 2 wire harness clamps.



    A247663

  1. Disconnect the battery cooling blower assembly connector and clamp.



    A247664

  1. Remove the 2 bolts, nut and battery cooling blower assembly.