POWER STEERING SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK STEERING EFFORT (TORQUE)

NOTICE:
Some of these service operations may affect the SRS airbags. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

  1. Stop the vehicle on a level, paved surface and align the wheels straight ahead.

  1. Remove the steering pad (Click here).

  1. Connect the cable to the negative (-) auxiliary battery terminal.

  1. Using a torque wrench, check that the steering wheel set nut is properly tightened.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

  1. Turn the power switch on (READY) so that the power steering is ready to operate.

  1. Turn the steering wheel 90 degrees to the right and check the steering effort (torque) while continuing to turn it further in the same direction.

    Standard steering effort (Reference):
    6.0 N*m (61 kgf*cm, 53 in.*lbf) or less

  1. Align the front wheels facing straight ahead.

  1. Disconnect the cable from the negative (-) auxiliary battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

  1. Install the steering pad (Click here).