LIGHTING SYSTEM > Diagnosis Circuit

for Preparation Click here


DESCRIPTION

The headlight leveling ECU assembly outputs DTC information to the intelligent tester via this circuit.

WIRING DIAGRAM


E143270E09


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (DLC3 - HEADLIGHT LEVELING ECU ASSEMBLY)

  1. Disconnect the A46 headlight leveling ECU assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Condition
    		Specified Condition
    A46-15 (PRST) - H44-7 (SIL)
    		Always
    		Below 1 Ω
    A46-15 (PRST) - Body ground
    		Always
    		10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)