AIRBAG SYSTEM > CHECK MODE PROCEDURE

for Preparation Click here



CHECK MODE (SIGNAL CHECK): DTC CHECK

  1. Turn the power switch off.

  2. Connect the intelligent tester to the DLC3.

  3. Turn the power switch on (IG).

  4. Turn the intelligent tester on.

  5. Enter the following menus: Body / SRS Airbag / Utility / Signal Check, and proceed with checking using the intelligent tester.

    NOTICE:
    Select Signal Check screen on the intelligent tester to clear the output DTCs (both current and history).

    HINT:
    1. DTCs can be detected more sensitively in check mode than in normal diagnosis mode.
    2. Perform check mode inspection when a malfunction in a squib circuit is suspected even after the normal system code is output through normal diagnosis mode inspection.