METER / GAUGE SYSTEM > FREEZE FRAME DATA

for Preparation Click here



FREEZE FRAME DATA

  1. Whenever a meter DTC is detected, the meter ECU stores the current vehicle state as Freeze Frame Data.


CHECK FREEZE FRAME DATA

  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the tester on.

  4. Enter the following menus: Body / Combination Meter / DTC.

  5. According to the intelligent tester display, select the trouble code data display with Freeze Frame Data.

  6. Read the Freeze Frame Data recorded when the DTC was set.

    Combination Meter 
    Tester Display
    		Measurement Item
    		Reference Value
    Exhaust heat management warning detected
    		The distance and time when the DTC stored
    		Min.: 0, Max.: 999999
    Lost Communication with ECM/PCM "A"
    		The distance and time when the DTC stored
    		Min.: 0, Max.: 999999
    Lost Communication with Brake System Control Module
    		The distance and time when the DTC stored
    		Min.: 0, Max.: 999999
    Lost Communication with Power Steering Control
    		The distance and time when the DTC stored
    		Min.: 0, Max.: 999999
    Lost Communication with Body Control Module "B"
    		The distance and time when the DTC stored
    		Min.: 0, Max.: 999999
    Lost Communication with Restraints Control Module
    		The distance and time when the DTC stored
    		Min.: 0, Max.: 999999


CLEAR FREEZE FRAME DATA

NOTICE:
Clearing the DTC will also clear the Freeze Frame Data.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Clear the DTC and Freeze Frame Data (Click here).