ENTRY AND START SYSTEM (for Start Function) > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to the system before inspecting the suspected areas below.


Entry and Start System (for Start Function) 
Symptom
Suspected Area
See page
Power source mode does not change to on (IG) or on (ACC)
Refer to "Power Source Mode does not Change to ON (IG and ACC)"
 Click here
Power source mode does not change to on (IG)
Refer to "Power Source Mode does not Change to ON (IG)"
 Click here
Power source mode does not change to on (ACC)
Refer to "Power Source Mode does not Change to ON (ACC)"
 Click here
Power source mode does not change to ON (READY)
Refer to "Power Source Mode does not Change to ON (READY)"
 Click here