SEAT MEMORY SWITCH > INSPECTION

for Preparation Click here



1. INSPECT SEAT MEMORY SWITCH (for LHD)


    B235920E09

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Switch Condition
    		Specified Condition
    1 (MRY) - 5 (E)
    		SET switch is pressed
    		Below 1 Ω
    2 (M1) - 5 (E)
    		M1 switch is pressed
    		Below 1 Ω
    3 (M2) - 5 (E)
    		M2 switch is pressed
    		Below 1 Ω
    4 (M3) - 5 (E)
    		M3 switch is pressed
    		Below 1 Ω
    1 (MRY) - 5 (E)
    		SET switch is not pressed
    		10 kΩ or higher
    2 (M1) - 5 (E)
    		M1 switch is not pressed
    		10 kΩ or higher
    3 (M2) - 5 (E)
    		M2 switch is not pressed
    		10 kΩ or higher
    4 (M3) - 5 (E)
    		M3 switch is not pressed
    		10 kΩ or higher

    Text in Illustration 
    *a
    		Component without harness connected
    (Seat Memory Switch)
    If the result is not as specified, replace the seat memory switch.



2. INSPECT SEAT MEMORY SWITCH (for RHD)


    B236453E01

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Switch Condition
    		Specified Condition
    1 (MRY) - 5 (E)
    		SET switch is pressed
    		Below 1 Ω
    2 (M1) - 5 (E)
    		M1 switch is pressed
    		Below 1 Ω
    3 (M2) - 5 (E)
    		M2 switch is pressed
    		Below 1 Ω
    4 (M3) - 5 (E)
    		M3 switch is pressed
    		Below 1 Ω
    1 (MRY) - 5 (E)
    		SET switch is not pressed
    		10 kΩ or higher
    2 (M1) - 5 (E)
    		M1 switch is not pressed
    		10 kΩ or higher
    3 (M2) - 5 (E)
    		M2 switch is not pressed
    		10 kΩ or higher
    4 (M3) - 5 (E)
    		M3 switch is not pressed
    		10 kΩ or higher

    Text in Illustration 
    *a
    		Component without harness connected
    (Seat Memory Switch)
    If the result is not as specified, replace the seat memory switch.