DTC    P0C30-390    Hybrid Battery Pack State of Charge High

for Preparation Click here


DESCRIPTION

The Power management control ECU monitors its internal operation, it will set DTCs and perform fail-safe control when it detects the following malfunctions.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0C30
390
Charge control error
Power management control ECU

INSPECTION PROCEDURE

1.CHECK DTC OUTPUT (HYBRID CONTROL)

  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Enter the following menus: Powertrain / Hybrid Control / DTC.

  1. Check if DTCs are output.

    Result:
    Result
    		Proceed to
    P0C30-390 only is output.
    		A
    DTCs other than P0C30-390 are output.
    		B

  1. Turn the power switch off.



B
GO TO DTC CHART (HYBRID CONTROL SYSTEM) (Click here)
A

REPLACE POWER MANAGEMENT CONTROL ECU (Click here)